Darning - Janome MEMORY CRAFT 4900 QC Instruction Book

q w
28
q
e
r
w
e
w

Darning

Machine settings
q Pattern:
w Presser foot:
e Thread tension:
z Pull the button holder to the rear as far as it will go.
q Button holder
x Place the garment under the foot.
Press the up/down needle position button twice.
Remove the fabric to the left to draw both threads under
the foot and place the fabric back under the foot.
c Lower the needle at the starting point, then lower the
foot.
w Starting point
v Depress the foot control and the machine will sew a
darning 2 cm (3/4˝) long and stop automatically.
Repeat sewing in a different direction until the darning
covers the rip or hole.
NOTE:
The maximum size of darning is 2 cm (3/4˝) long and 0.7
cm (1/4˝) wide.
e Maximum length 2 cm (3/4˝)
r Maximum width 0.7 cm (1/4˝)
t Starting point
5 3
28 (mode 2)
Automatic buttonhole foot R
AUTO