Functional Description - Makita AN450H Instruction Manual

FUNCTIONAL DESCRIPTION

CAUTION:
Always disconnect the air hose before adjusting or
•
checking function on the tool.
Adjusting depth of nailing
009537
To adjust the depth of nailing, turn the adjuster. The
depth of nailing is the deepest when the adjuster is
turned fully in the A direction shown in the figure. It will
become shallower as the adjuster is turned in the B
direction. If nails cannot be driven deep enough even
when the adjuster is turned fully in the A direction,
increase the air pressure. If nails are driven too deep
even when the adjuster is turned fully in the B direction,
decrease the air pressure. Generally speaking, the tool
service life will be longer when the tool is used with
lower air pressure and the adjuster set to a lower depth
of nail driving.
CAUTION:
Always disconnect the hose before adjusting the
•
depth of nailing.
Hook
009538
CAUTION:
Always disconnect the hose from the tool.
•
Never hook the tool at high location or on
•
potentially unstable surface.
The hook is convenient for hanging the tool temporarily.
1. Adjuster
1
1. Hook
1
Adjusting the shingle guide
2
1
3
009548
009551
The shingle guide is designed for consistent shingle
exposure. Place shingle in desired position.
Turn the lever clockwise to release the adjusting plate.
Reset the tool on the exposed shingle with the
projections of the contact element depressing the bottom
of the previous row of the shingle. Slide the adjusting
plate up against the bottom of the exposed shingle and
turn the lever counterclockwise to lock the adjusting plate.
ASSEMBLY
CAUTION:
Always disconnect the air hose before carrying out
•
any work on the tool.
Loading nailer
1
009547
Select nails suitable for your work. Depress the latch
lever and open the magazine cap.
Lift and turn the coil support plate so that the arrow with
nail size indicated on the coil support plate will point to
the corresponding graduation increment marked on the
magazine. If the tool is operated with the coil support
plate set to the wrong step, poor nail feed or malfunction
of the tool may result.
5
1. Contact element
2. Shingle guide
3. Shingle
4
4. Projection
1. Lever
2. Adjust plate
1
2
1. Magazine cap
2. Latch lever
2