Belt Pulley Removal; Motor Capstan Ass'y Removal - Sony SLV-D910AZ Service Manual

2-4-25 Belt Pulley Removal

1) Remove the Belt Pulley 1.
Note: Take extreme care not to get grease on Belt Pulley 1 at
assembling or reassembling.
1 BELT PULLEY
Fig. 2-38 Belt Pulley Removal

2-4-26 Motor Capstan Ass'y Removal

1) Remove the Damper Capstan 1 in the direction of arrow.
2) Remove the 3 Screws 2.
3) Remove the Motor Capstan Ass'y 3.
Assembly:
1) Match the 3 holes of Motor Capstan Ass'y 3 to the 3 holes of
Main Base. Be careful not to drop or knock the Motor Capstan
Ass'y 3.
2) Tighten the 3 Screws 2 in the direction of arrow as shown detail
drawing.
3) Assemble the Damper Capstan 1.
Note: After tightening screws, check if there is gap between the head
of screws and the top side of Main Base. There should have no gap
between the head of screws and the top side of Main Base.
After reinstalling, adjusting the tape transport
system again.
1 3 SCREWS
Fig. 2-39 Motor Capstan Ass'y Removal
2-19
C
A
B
2 MOTOR CAPSTAN ASS'Y