Wifi Antenna - HP 10 Plus 2201 User Manual

Hp 10 plus 2201 tablet and hp 10 2101 tablet
Table of Contents

Advertisement

3.
Unsolder the right speaker cables (2) from the contact points on the system board.
NOTE:
cable should be soldered to the system board "positive" terminals. The right and left speaker black
cables should be soldered to the system board "negative" terminals.
4.
Release the tape (3) that secures the speaker cables to the battery.
5.
Remove the four Phillips PM1.6×4.1 screws (4) that secure the speakers to
the display panel assembly.
6.
Remove the speakers (5).
Reverse this procedure to install the speakers.

Wifi antenna

NOTE:
The Wifi antenna is included in the Antenna Kit, spare part number 784327-001.
Before removing the Wifi antenna, follow these steps:
1.
Turn off the tablet. If you are unsure whether the tablet is off or in Hibernation, turn the tablet on,
and then shut it down through the operating system.
2.
Disconnect the power from the tablet by unplugging the power cord from the tablet.
3.
Disconnect all external devices from the tablet.
4.
Remove the back cover (see
When installing the speakers, the right speaker red cable and the left speaker white
Back cover on page
15).
Wifi antenna
19

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

10 2101

Table of Contents