Philips SC2008 User Manual page 28

Light-based hair removal
Hide thumbs Also See for SC2008:
Table of Contents

Advertisement

ENGLISH
28
Problem
I have switched on the
appliance but I cannot
increase or decrease the
light intensity.
The 'ready to flash' light
does not go on when I
place the appliance on
the skin.
The 'ready to flash' light
does not go on when I
place an attachment on
my skin, but the cooling
fan works.
The 'ready to flash' light is
green but the appliance
does not produce a flash
when I press the flash
button.
The appliance becomes
warm during use.
The appliance does not
show light intensity 1
when I switch it on.
Possible cause
Solution
The adapter is not
Make sure the adapter is inserted properly into the
inserted properly
wall socket and/or the small plug is inserted properly
into the wall socket
into the appliance socket.
and/or the small
plug is not inserted
properly into the
appliance socket.
The appliance is
Contact the Consumer Care Centre in your country,
defective.
your Philips dealer or a Philips service centre.
The appliance has
To reset the appliance, switch off the appliance and
to be reset.
then switch it on again. If you still cannot adjust the light
intensity, contact the Consumer Care Centre in your
country, your Philips dealer or a Philips service centre.
You have not put
Place the appliance at a 90° angle onto the skin in such
the attachment with
a way that all contact switches touch the skin. Then
safety ring properly
check if the 'ready to flash' light is on and press the
on the skin.
flash button.
If this does not work, place the appliance on a part
of your body where it is easy to establish full skin
contact, for example on your lower arm.Then check
if the 'ready to flash' light works. If the 'ready to flash'
light still does not go on when you place the appliance
on the skin, contact the Consumer Care Centre in your
country, your Philips dealer or a Philips service centre.
The safety ring is
Clean the safety ring carefully. If you are unable to clean
dirty.
the safety ring properly, contact the Consumer Care
Centre in your country, your Philips dealer or a Philips
service centre to replace the attachment.
The overheat
When the overheat protection has been activated, the
protection has
fan still works. Do not switch off the appliance and let it
been activated.
cool down for approx. 15 minutes before you continue
to use it. If the 'ready to flash' light still does not go on
when you place the appliance on the skin, contact the
Consumer Care Centre in your country, your Philips
dealer or a Philips service centre.
The appliance
To reset the appliance, switch off the appliance and switch
needs to be reset.
it on again. If the 'ready to flash' light is green but the
appliance still does not produce a flash when you press the
flash button, contact the Consumer Care Centre in your
country, your Philips dealer or a Philips service centre.
This is normal.
No action required.
The appliance
To reset the appliance, switch it off and on again. If the
needs to be reset.
appliance still does not show light intensity 1, contact
your Customer Care Centre, your Philips dealer or a
Philips Service Centre.

Advertisement

Chapters

Table of Contents
loading

This manual is also suitable for:

Sc2006

Table of Contents