INSTALLATION AND WIRING
2.3
Wiring
(1) Untwist the twisted pair shielded cables after stripping its sheath.
Also, perform protective treatment of the shield to ensure that it will not
make contact with the conductive area.
Strip off the sheath about the size as in the below figure. If the length of
the sheath pealed is too long, a short circuit may occur among
neighboring wires. If the length is too short, wires might come off.
Wire the stripped cable after twisting it to prevent it from becoming loose.
(Do not solder it.)
Cable stripping length
Use a bar type terminal as required.
8
5mm
Shield
(perform protective treatment)
Sheath
Twisted pair
shielded cable