Kenwood DNN9250DAB Quick Start Manual page 25

Ñ Unit
1) To prevent a short circuit, remove the key from
the ignition and disconnect the ¤ terminal of
the battery.
2) Make the proper input and output wire
connections for each unit.
3) Connect the wire on the wiring harness.
4) Take Connector B on the wiring harness and
connect it to the speaker connector in your
vehicle.
5) Take Connector A on the wiring harness and
connect it to the external power connector on
your vehicle.
6) Connect the wiring harness connector to the
unit.
7) Install the unit in your car.
8) Reconnect the ¤ terminal of the battery.
9) Press the <Reset> button. (P.4)
10) Perform the Initial Setup.
See First Step (P.7).
✎
NOTE
• Make sure that the unit is installed securely in place.
If the unit is unstable, it may malfunction (eg, the
sound may skip).
Bend the tabs of the
mounting sleeve with
a screwdriver or similar
utensil and attach it in
place.
Ñ Attaching the front panel
(DNN9250DAB/ DNR8025BT)
Hold the front panel securely so as not to drop it
accidentally. Fit the panel onto the attaching plate
until it is firmly locked.
1
2
3
Ñ Trim plate
1) Attach accessory 5 to the unit.
4
1
5
25
English ñ