Download  Print this page

Keithley 7711 User Manual Page 35

Hide thumbs

Advertisement

Table of Contents
7712 50Ω Ω 3.5
3.5GHz Multiplexer
GENERAL
Relay Type: High Frequency Electromechanical
Contact Configuration: Dual 1x4 Multiplexer, single pole four
throw, Channels 1 and 5 are normally closed
Notes: One channel in each multiplex bank is always closed to the
corresponding OUT connector.
Close Channel: ROUTe:CLOSe allows a single channel in a
multiplex bank to be closed.
ROUTe:MULTiple:CLOSe allows two channels (One in each bank)
to be closed at one time.
Open Channel: ROUTe:OPEN:ALL closes CH1 and CH5 to OUT A
and OUT B respectively.
Actuation Time: <10mS
Firmware: Specified for Model 2700 rev. B04 and
Model 2750 rev. A03 or higher.
Connector Type: Ten External Rear Panel SMA connectors
Mating Torque: 0.9 N•m (8 in-lb).
INPUTS (CHANNELS 1-8)
Maximum Signal Level: Any channel to any channel or chassis (1-8)
30Vrms (42V peak for AC waveforms) or
42VDC, 0.5A.
Maximum Power: 20W per module. 10W per channel.*
Safety: Conforms to European Union Directive 73/23/EEC
EN61010-1, CAT I.
EMC: Conforms with European Union Directive 89/336/EEC;
EN61326-1.
Isolation:
Multiplexer to Multiplexer: >1GΩ
Center to Shield: >1GΩ, <20pF
Channel to Channel: >100MΩ
Contact Life: 5x10
6
No Load, 1x10
Contact Potential: <12µV
Contact Resistance: <0.5Ω (Initial), <1Ω (End Of Life)
Rise Time: <200ps (Guaranteed by design)
Signal Delay: <1.5ns
MODEL ACCESSORIES AVAILABLE
7712-SMA-1
SMA cable, male to male, 1m (3.3 ft)
7712-SMA-N
Female SMA to Male N-Type Adapter
S46-SMA-1
SMA cable, male to male, 0.3m (1ft)
S46-SMA-0.5
SMA cable, male to male, 0.15m (0.5 ft.)
* Refer to 7711/7712 User's Guide (PA-818) for measurement
considerations.
5
Rated Load (Resistive load)
Frequency (MHz)
Frequency (MHz)
Frequency (MHz)
HW 2/05/02
Rev. A
Page 1 of 2

Advertisement

Table of Contents

   Related Manuals for Keithley 7711

This manual is also suitable for:

7712

Comments to this Manuals

Symbols: 0
Latest comments: