Parts - Mitsubishi Electric FR-A7ND E kit Instruction Manual

1.2

Parts

Connector for communication
Mount the accessory terminal
block to connect to the network.
V-
CAN-
SW1
SHIELD
CAN+
V+
Mounting
hole
Node address switch
Set the node address.
(Refer to page 12.)
CAUTION
• Set the compatible mode switch (SW3) before switching ON the inverter and do not change the setting
while the power is ON. Otherwise you may get an electric shock.
• Do not turn ON the switch 2 of the compatible mode switch (SW3).
Front view
0 0
LED1
2
1
SW2
X10 X1
MNS
FR-A7ND
Connector
Connect to the inverter
option connector.
Compatible mode switch (
Switch over to the FR-E5ND
(FR-E500-KND) compatible mode.
(Refer to page 89.)
(In the initial status, the switches
1 and 2 are both OFF.)
PRE-OPERATION INSTRUCTIONS
MNS LED (operation status indication)
Lit/flicker/off of the LED indicate inverter
operation status.
Rear view
SW4
Mounting
hole
SW3)
(Refer to page 4.)
Mounting hole
Switch for manufacturer setting
Do not change from initially-set
status (OFF).
SW4
O
N
1
3