Use the right side of the system board (1) immediately behind the optical drive connector to lift the
5.
right side of the system board (2) until the rear left corner of the system board (3) clears the base
enclosure.
Remove the system board (4) by pulling it away from the top cover at an angle until it clears the top
6.
cover.
If it is necessary to replace the optical drive connector board, pull the board away from the system
7.
board until it disconnects from the system board.
NOTE:
The optical drive connector board is available using spare part number 443820-001.
When replacing the system board, be sure that the following components are removed from the defective
system board and installed on the replacement system board:
SIM (see
●
Memory modules (see
●
on page
WLAN module (see
●
RTC battery (see
●
90
Chapter 4 Removal and replacement procedures
SIM on page
49)
Expansion memory module on page 56
66)
WLAN module on page
RTC battery on page
58)
67)
and
Internal memory module
ENWW