Heat Operation - Mitsubishi Electric CITY MULTI PKFY-P24NKMU-E Technical & Service Manual

6-4. HEAT OPERATION

TIME SUN MON TUE WED THU FRI SAT
TIMER
AFTER
ERROR CODE
û Fû C
û Fû C
ONLY1Hr.
TEMP.
MENU ON/OFF
BACK MONITOR/SET DAY
OPERATION
PAR-21MAA CLOCK
Control modes
1-1. Thermoregulating function (Function to prevent restarting for 3 minutes)
1. Thermoregulating
function • Room temperature
• Room temperature
By the remote controller setting (switch of 2 speeds)
2. Fan
2-1. Hot adjust mode
The fan controller becomes the hot adjuster mode for the following conditions.
A: Hot adjust mode starts.
B: 5 minutes have passed since the condition A or the indoor liquid pipe
C: 2 minutes have passed since the condition B. (Terminating the hot adjust mode)
2-2. Residual heat exclusion mode
<How to operate>
Press POWER ON/OFF button.
Press the operation MODE button to display HEAT.
Press the TEMP. button to set the desired temperature.
Hr ON
AFTER OFF
FUNCTION NOTE: The set temperature changes 2°F when the
FILTER
WEEKLY
SIMPLE
AUTO OFF
ON/OFF
<Display in HEAT operation>
FILTER
[DEFROST]
CHECK TEST
The [DEFROST] symbol is only displayed during the defrost operation.
CLEAR
[STANDBY]
The [STANDBY] symbol is only displayed during the hot adjust mode.
desired temperature -2°F ···Thermo ON
desired temperature
Type
2 speeds
When starting the HEAT operation
When the thermoregulating function changes from OFF to ON.
When release the HEAT defrosting operation
Hot adjust mode *1
[Low]
[Extra Low]
A B
temperature turned 95°F or more.
When the condition changes the auxiliary heater ON to OFF (thermoregulating or
operation stop, etc), the indoor fan operates in [Low] mode for 1 minute.
pressed one time. Heating 63 to 83°F.
Control details
···Thermo OFF
Fan speed notch
[Low], [High]
Set fan speed by the remote controller
C
12
or button is
*1 "STAND BY"
will be displayed
during the hot
adjust mode.
· This control is
same for the
model without
auxiliary heater.
To be continued on the next page.
Remarks