Sony KDF-46E3000 Service Manual page 23
Lcd projection television
Hide thumbs
Also See for KDF-46E3000:
- Operating instructions manual (52 pages) ,
- Quick setup manual (2 pages) ,
- Specifications (2 pages)
Table of Contents
Advertisement
OVERALL ASSEMBLY (CONTINUED)
Dress 8P connector from [BE] to clips on Main Brkt.
RED Tape should line up with clips. This connector
should be on top of LVDS Connector
Secure HARNESS ASSY
with 20 X 40 HIMELON tape
Secure Ballast Power with 20 X 40
HIMELON tape as shown
KDF-46E3000/50E3000
Dress 8P connector to clip
under LVDS connector
Route Ballast Power as shown and
install to wire holders
Route 4P Speaker and 9P HAE connector
as shown before installing Seperator Blk
A
KDF-46E3000/50E3000
Install Ferrite Clamp
(146908911) to HARNESS
ASSY as shown.
CRITICAL FOR EMI
Install Ballast Power to [G], install Ferrite Clamp
(146908911) and dress to wire pin on [G] as shown.
Ferrite Clamp must be vertical and
as close to Connector as possible
CRITICAL FOR EMI
After installing Separator Blk Assy ensure
4P and 9P Connetor are not pinched
between Rear cover and Separator
Page 23
Hide quick links:
Advertisement
Table of Contents
