Kenmore 116.23101C Owner's Manual page 17

PIÈCES ET CARACTÉRISTIQUES
Il est important de connaître les pièces et les caractéristiques de l'aspirateur pour l'utiliser correctement et en
toute sécurité. Lire cette section avant de l'utiliser.
POWER-MATE ®
Pièce Nº aux Nº Au
Etats-Unis Canada
Courroie 20-5279 20-40111
Porte-cordon
Réglage de
la hauteur
Protecteur de
surcharge (Bouton
de remise en marche)
Porte - fiche
Porte - cordon
Cordon
Power-Mate ®
Tube
Porte-cordon
Tube
Courroie
Aspiration de coin
(Non ilustré)
4
TO CLEAN AGITATOR:
NOTE: In order to keep cleaning efficiency
high and to prevent damage to your vacuum
cleaner, the agitator must be cleaned every
time the belt is changed.
The agitator must also be cleaned accord-
ing to the following schedule:
Vacuum Cleaner Use Clean Agitator
HEAVY - every week
(used daily)
MODERATE - every month
(used 2-3 times/week)
LIGHT - every 2 months
(used 1 time/week)
IMPORTANT
Turn off and unplug vacuum cleaner from
electrical outlet. Check and remove hair,
string and lint build-up frequently in the
®
Power-Mate agitator and end cap areas.
Remove any dirt or debris in the belt path
area or in the brush roller area.
Carefully remove any string or debris
located on the agitator or end caps.
AGITATOR ASSEMBLY
End
Cap
Brush Unit
End
Cap
Belt Groove
TO REPLACE BELT
1. Install new
belt in belt
groove on the
agitator
Belt
assembly,
Motor Shaft
then over the
motor shaft. Belt
Guard
Be sure belt is
under the belt
guard.
NOTE: See PARTS AND FEATURES for
Belt number.
2. Insert
both support
tabs into the
base slots.
Then snap
Front
end caps into
Support
place.
Tab
3. Line up
tabs on front
of base with
slots inside
the front
cover.
Cover
Front
Slot
Base Tab
4. Tilt cover to
back. Press
cover firmly
until rear tabs
snap into
place.
Rear Base Tab
5. Turn Power-Mate ® over. Replace the
cover screws and lower the pile height
adjustment rollers into place.
17