Bosch SHI4302 Manual page 51

VI. Component Access/Replacement
VI. Component Access/Replacement
Heaters &
Heaters &
To separate base from tank (2):
Disconnect J-box ground wire,
then pull wires out of J-box.
Pull out inlet hose from sump.
Carefully pull base away from
tank and sump.
Pull wires from J-box
Carefully pull base away from tank & sump
HINT: Don't order duplicate parts when ordering parts below --
when these parts are replaced, others are included:
• Heater assy. -- includes NTC, Hi-Limit, flow switch (& aqua
sensor where applicable).
• NTC -- includes Hi-Limit.
NTC's – Access (4)
NTC's – Access (4)
Pull out sump inlet hose
49
Its simpler &
HINT:
quicker to remove the
two water valve screws
than to remove the
hose clamp.