The Griddle; Grill; Control Panel And Doors - Rangemaster 110 Gas User's Manual & Installation Instructions

Fig.5.5
ArtNo.330-0003 - Grill pan w handle pulled forwards
Fig.5.6

The Griddle

Always clean the griddle after use. Allow it to cool completely
before removing. Immerse the griddle plate in hot soapy
water. Use a soft cloth or, for stubborn stains, a nylon washing
up brush.
Note: If the griddle is washed in a dishwasher then some
dishwasher residue may appear on the back. This is normal
and will not affect the performance of your griddle.

Grill

The face of the grill burner will darken with use – this is
perfectly normal. Any fat or grease will burn off. Do not try to
clean it – the small holes could get blocked and affect burner
performance.
The grill pan can be easily removed for cleaning (
The grill pan and trivet should be washed in hot soapy water,
alternatively, the grill pan can be washed in a dishwasher.
After grilling meats or any foods that soil, leave to soak for
a few minutes in the sink immediately after use. Stubborn
particles may be removed from the trivet by using a nylon
brush.
Before you remove any of the grill parts for cleaning make
n n
sure that they are cool, or use oven gloves.
DO NOT use any abrasive substances.
n n

Control Panel and Doors

Avoid using any abrasive cleaners including cream cleaners.
For best results, use a liquid detergent.
The same cleaner can be used on the doors or alternatively
using a soft cloth wrung out in clean hot soapy water – but
take care that no surplus water seeps into the appliance.
After cleaning, polish with a dry cloth.
Glass Fronted Door Panels
The oven door front panels can be taken off so that the glass
panels can be cleaned. Move the cooker forward to gain
access to the sides (see the 'Moving the Cooker' section under
'Installation').
Open the oven door slightly and remove the front panel
fixing screws from the door sides, two each side (
Carefully lift off the outer door panel. The inside face of the
glass panels can now be cleaned – take care not to disturb or
wet the door insulation.
Note: If the door is triple glazed then the inner two panels are
fixed together and should not be separated. After cleaning,
carefully refit the outer door panel and replace the side fixing
screws.
16
).
Fig.5.5
(some models)
).
Fig.5.6