Replacing The Lamp - Hitachi PJ-TX10W User Manual

Lamp (continued)

Replacing The Lamp

WARNING • Please carefully read the "User's Manual - Safety Guide".
CAUTION • Do not reset the lamp timer without replacing the lamp.
• When you replace the lamp, please replace also the air filter. The air filter may be
attached when you buy a replacement lamp for this projector. Please ask your dealer.
If the indicators or a message prompts you to replace the lamp, replace the lamp as soon
as possible. Using the lamp for long periods of time, or past the replacement date, could
cause it to burst. If the projector is mounted on the ceiling, or if the lamp has broken, do
not try to clean the projector or replace the lamp yourself.
Turn off the projector, and unplug the power cord. Allow the lamp
1
bulb to cool for at least 45 minutes.
Contact your local dealer to prepare a new lamp. Tell the dealer
2
your lamp type number. If the projector is mounted on the ceiling,
or if the lamp has broken, also ask the dealer to replace the lamp.
In the case of replacement by yourself,
After making sure that the projector
3
has cooled adequately, slowly flip
over the projector, so that the bottom
is facing up.
Unscrew the screw of the lamp cover,
4
then slide and take the lamp cover up.
Unscrew the 2 screws, and slowly
5
pick up the lamp by the handles.
Insert the new lamp, and tighten the 2
6
screws firmly to lock it in place.
Slide the lamp cover into place, and tighten the screw of the lamp
7
cover firmly.
Slowly turn the projector so that the top is facing up.
8
Turn on the projector, and reset the lamp timer. When the lamp has
9
been replaced after the message of "THE POWER WILL TURN OFF
AFTER 0hr." is displayed, complete the following operation within
10 minutes of switching power on.
(1) While the projector running, press the MENU button to open the menu.
(2) Choose the "OPTION" on the menu using the
or ENTER button.
(3) Choose the "LAMP TIME" using the
of projector or the RESET button of remote control for 3 seconds.
(4) Choose the "RESET" using the
32
Lamp cover
button, then press the
/
button, then press and hold the
/
button.
Screw
Handles
Screws
button
button