ROTOR ASSEMBLY, STATOR ASSEMBLY, FRICTION DAMPER ASSEMBLY
Clean the drain pump filter
Open the lower cover cap (
using a coin. Turn the drain plug
) to pull out the hose.
Unplug the drain plug (
the water flows out, At this time
use a vessel to prevent water from
flowing on the floor. If the water
does not flow any more, turn the
pump filter (
Remove the BACK COVER.
Unscrew the bolt to pull out the ROTOR assembly.
Disconnect the wiring connector.
Unscrew 6 bolts from the STATOR.
Remove the STATOR.
Note : Hook of connector (1) is on the backside
Pull out the hinge, pressing its snap.
Do not use the pulled-out hinge again. It may be
taken off during operation.
) , then
) open to the left.
Take out any foreign material from
the pump filter (
cleaning, turn the pump filter(
clockwise and insert the drain plug
) to the original place. close
the lower cover cap.