Inserting Batteries in the
Remote Control Handset
• Remove the battery cover located on the back
of the handset by gently pulling backwards
from the indicated part.
• Insert two AAA/R3 or equivalent type batteries
inside. Place the batteries in the right
directions and replace the battery cover.
Handling the Remote Control
•
Improper use
could cause corrosion or
battery leakage and may result in physical
injury and/or property damage including fire.
• Never mix used and new batteries in the
device.
• Replace all the batteries in a device at the
same time.
• Remove the batteries if the remote control is
not going to be used for an extended period
of time.
• To avoid possible failure, read the following
instructions and handle the remote control
properly.
• Do not drop or cause impact to the remote
control.
• Do not spill water or any liquid on the remote
control.
• Do not place the remote control on a wet
object.
• Do not place the remote control under the
direct sunlight or near sources of excessive
heat.
HITACHI-ENG-19856W-UK IDTV-1055UK-VGA-(LIPS)-10059155-50138612.p65
Note: Remove the
Operating Range for the
Remote Control
• Point the top of the remote control toward
the LCD TV's remote sensor LED while
pressing a button.
Remote range is approximately 7m/23ft.
- 16 -
16
batteries
control handset when it is not to be
used for a long period. Otherwise, it can
be damaged due to
battery leakage.
30
30
ABC
DEF
GHI
1
2
3
JKL
MNO
PQR
4
5
6
STU
VWX
YZ
7
8
9
0
-/--
AV
SOU RCE
EXIT
INFO
I-II
P /CH
O K
MENU
TV/DTV
WIDE
GUIDE
P < P/SW AP
PP
13.11.2008, 12:58
from remote