Download  Print this page

Using The Remote Control; Battery Installation - Mitsubishi Electric XL5950U User Manual

Srgb.
Hide thumbs

Advertisement

Using the remote control

Battery installation

Use two AA size batteries.
1. Remove the back cover of the remote control by pushing the battery compartment door in the direction of the
arrow.
2. Load the batteries making sure that they are positioned correctly (+ to +, and - to -).
• Load the batteries from - spring side, and make sure to set them tightly.
3. Replace the back cover.
1
Important:
• Do not use a new battery with an old one.
• Load batteries in the correct position.
• Do not heat, take apart, or throw batteries into fire.
• Do not try to recharge batteries. Do not use rechargeable batteries.
• If the solution of batteries comes in contact with your skin or clothes, rinse with water. If the solution comes
in contact with your eyes, rinse them with water and then consult your doctor.
Operation area (for wireless control system)
The range for operation is about 10 m (about 32 feet) when the remote control points to the projector. The dis-
tance to the screen back to the projector must be less than 7 m (about 23 feet). Depending on the type of the
screen, the distance will be different.
30˚
30˚
Important:
Avoid the direct sunlight or fluorescent light to the remote control sensor. Also keep the distance of more than 2 m
(6.5 feet) between the remote control sensor and fluorescent lamp on the remote control may not work correctly.
Using the wired remote control
Attached remote control for this projector can be used as a wired remote control with remote control cable. Wired
remote control is useful for operating in a distance or outside of the operating area.
• When REMOTE OUT terminal on this projector is connected to
the REMOTE OUT terminal on the other projector, the two
projectors can be controlled together by using the remote
control. (Up to two projectors can be controlled.)
EN – 8
2
20˚
15˚
REMOTE IN
REMOTE
REMOTE
INPUT 1
IN
OUT
INPUT 2
MAIN
AC IN
REMOTE OUT
REMOTE IN
3
20˚
15˚
20˚
• When the remote control is connected
with remote control cable, it does not
work as a wireless remote control.
USB
RS-232C
RS-232C/MOUSE
R/P
R
G/Y
B/P
B
H/H
V
V
• For connection, use the pin-pin cable of
AUDIO
VIDEO
IN
2
S-VIDEO
Y
ø3.5 stereo type, which is commercially
VIDEO
1
AUDIO
OUT
C
L
available. However, some cable may not
AUDIO
R
work correctly.
• When using the wired remote control, the
laser beam may be darker. It is normal.
20˚

Advertisement

Table of Contents

   Also See for Mitsubishi Electric XL5950U

   Related Manuals for Mitsubishi Electric XL5950U

This manual is also suitable for:

Xl5900luXl5900uXl5950lu

Comments to this Manuals

Symbols: 0
Latest comments: