Setup / Mounting Instructions - Halex Madison II Owner's Manual And Instructions

Halex Electronic Dartboard _ 3

Setup / Mounting Instructions

Choose a location to hang the dartboard where there is about 10 feet of open space in
front of the board. The "toe-line" should be 7' 9 1/4" from the face of the dartboard. Since
this dartboard is powered with an AC adapter, you may want to mount it close to an electric
outlet for convenience.
The mounting holes on this dartboard set are 16" apart so it can be mounted securely on
wall studs in your home. Locate a wall stud and place a mark 79 3/4" from the floor.
Measure 16" from your first mark (staying level with the first mark) and place the second
mark on the wall, which should be over another wall stud (refer to diagram on next page).
Screw 2 mounting screws in the center of the studs using the marks you made as guides.
Be sure the screws are level to ensure an accurate playing surface. If not mounting into
studs, be sure to use drywall anchors or other securing hardware appropriate to the wall
you are using.
Mount the dartboard on the wall by lining up the hang holes on the back with the screws
(see diagram below). It may be necessary to adjust the screws until the board fits snugly
against the wall. If you want to mount the dartboard even more securely to the wall, you
can fasten four screws through the holes located in the catch ring area (the area outside
the scoring segments).
 16" 
Hang Hole
Hang Hole
Back of Dart Board