Honda CRF70F 2004 Owner's Manual page 100

Installation
1. Reverse the removal procedure. Make sure
the lug ( ) on the swingarm is located in the 6
slot ( ) in the brake panel ( ). Check that 7
the chain adjusters are installed properly.
2. Adjust the drive chain (page
3. Torque the rear axle nut to:
43 lbf·ft (59 N·m , 6.0 kgf·m)
4. Adjust the rear brake (page
5. Apply the rear brake, release it, then spin the
wheel and check that it rotates freely. Repeat
this procedure several times.
If a torque wrench was not used to install the
wheel, see your Honda dealer as soon as
possible to verify proper assembly. Improper
assembly may lead to loss of braking capacity.
8
100 ).
84 ).
Wheels
Servicing Your Honda
91