Table of Contents
Advertisement
Important Information
Wiring the plug (UK and Eire only)
The mains lead on this product is already fitted with a non-rewireable (moulded) plug incorpo-
rating a fuse, the value of which is indicated on the pin face of the plug.
Should the fuse need to be replaced, an ASTA or BSI approved BS 1362 of the same rating
fuse must be used. If the fuse cover is detachable, always refit the cover after replacing the
fuse.
NEVER use the plug with the fuse cover omitted. If the fitted plug is not suitable for your socket
outlets, it should be cut off, after having first removed the fuse, and an appropriate plug fitted
in its place. If this new plug contains a fuse, its value should be the same as that removed from
the non-rewireable plug.
The severed plug must be destroyed immediately to avoid possible shock hazard. If you need
to replace the mains plug, follow the instructions given below:
The wires in the mains lead are coloured in accordance with the following code:
BLUE - Neutral (N):
BROWN - Live (L). As these colours may not correspond with the coloured markings identify-
ing the terminals in your plug, proceed as follows:
The wire coloured BLUE must be connected to the terminal marked with the letter N or col-
oured BLUE or BLACK.
The wire coloured BROWN must be connected to the terminal marked with the letter L or
coloured BROWN or RED. On no account should either of these wires be connected to the
terminal marked E or coloured GREEN or GREEN and YELLOW.
Before replacing the plug cover, make certain that the cord grip is clamped over the sheath of
the lead: not simply over the two wires.
If in doubt, consult a qualified electrician.
Nokia and Nokia Connecting People are registered trademarks of Nokia Corporation
66 76986-18
www.nokia.com
© 0226
Advertisement
Table of Contents
