Acquisitioncontrol - Toshiba teli BG030 Instruction Manual

AcquisitionControl

Make a setting of image stream and control image stream output.
Camera starts image stream output by receiving AcquisitionStrat command. And there are some registers
that require camera to stop image stream output to change values.
Acquisition frame rate is variable. Maximum acquisition frame rate depends on camera operation mode
(scalable, binning, draft, link speed, etc.)
● Registers
Register
AcquisitionMode
AcquisitionStart
AcquisitionStop
AcquisitionAbort
AcquisitionFrameRate
● Setting
- Start image stream output
The camera starts image stream output by executing "AcquisitionStart" register command.
- Stop image stream output
The camera stops image stream output by executing "AcquisitionStop" register command.
The camera aborts image stream output by executing "AcquisitionAbort" register command.
- Sets frame rate
Set the following value to "AcquisitionFrameRate" register. Setting value is Float type.
The range of register setting depends on camera model, and camera operation mode.
setting value
Minimum
Maximum (*)
Copyright © 2012 TOSHIBA TELI CORPORATION, All rights reserved.
Visibility Access
Beginner R Returns acquisition mode.
Beginner W Executes the image stream output start.
Beginner W Executes the image stream output stop.
Beginner W Executes the image stream output abort.
Beginner R/W Sets frame rate of image stream.
Depend on register setting of "Height" and "Binning" or link speed of interface.
Description
FrameRate
0.0625[Hz]
40 / 69
* initial factory setting
D4211908D
http://www.toshiba-teli.co.jp/index.htm