Download  Print this page

Advertisement

Installation (Continued)
Run the power cable through the hole in the back
of the appliance, and pull it through the appliance.
4
Warning
Use single phase 220 240V power.
Using the incorrect power supply may cause fires, electric shocks or
malfunctions.
Wire it to the terminal block. (No polarity)
1.Remove 15mm of wire sheath from the end.
2.Screw the power cable to the terminal block.
Proper torque is 1.2Nm(11 lbf·in)
Terminal
block
Screw
5
3.Check that the power cable is securely fixed
to the terminal block.
4.Wire the ground wire to the center terminal
of the terminal block.
Proper torque is 1.2Nm(11 lbf·in)
5.Clip and screw the power cable into the
position shown on the right.
Power cable
Power cable
70mm
15mm
Power
cable
Terminal
block
screw
Ground wire
Power cable hole
8
Hole
Power cable
Power cable
Cord clip
(Included)
Mounting
screw
Cord clip mounting screw hole
Terminal
block

Advertisement

This manual is also suitable for:

Jt-sb216jsh-s-eJt-sb216ksn-w-eJt-sb216jsh-h-e

Comments to this Manuals

Symbols: 0
Latest comments: