Connecting The Watchdog Cable - Bosch DESAXL Instruction Manual

XL
DÉSA | Instruction Manual | Installation

5.9 Connecting the Watchdog Cable

The purpose of the Watchdog cable and card is to
provide:
• Sensor Input Functions
• Control Output Functions
• PTZ Control
• Watchdog Monitoring Functions
• Remote Event Status
NOTE: The Watchdog cable must always be used so
the system functions properly.
5.9.1 Locate the supplied cable with the two DB-9
connectors, and one DIN connector end.
5.9.2 Connect the DB-9 connector end (that has two
cables going into it) to COM 1.
5.9.3 Connect the DIN (barrel connector) to the
receiver on the Watchdog Card.
5.9.4 Connect the DB-9 connector (with a single
cable) to a PTZ converter box (if used).
Bosch Security Systems | November 17, 2004
EN | 13