Adjusting The Volume - JVC RX-8010VBK Service Manual

Notes:
• When connecting an MD recorder (to the TAPE/MD jacks), and a
DBS tuner (to the TV SOUND/DBS jacks), change the source
names shown on the display. For details, see page 16.
• When you press one of the source selecting buttons on the remote
control marked with an asterisk (
on.
Signal and speaker indicators on the display
The signal indicators light up in the following cases:
• Only the indicators for the incoming signals light up.
• When analog input is selected, "L" and "R" always light up.
• When "DVD MULTI" is selected as the source, "L," "C," "R,"
"LFE," "LS" and "RS" light up.
The speaker indicators light up only —:
The frames of "C," "LS," and "RS" light up, when the
corresponding speaker is set to "LARGE" or "SMALL".
Signal indicators light up in
red:
C C
L L R R
SUBWFR SUBWFR LFE LFE
LS LS S S RS RS
L:
• When digital input is selected: Lights up when the left
channel signal comes in.
• When analog input is selected: Always lights up.
R: • When digital input is selected: Lights up when the right
channel signal comes in.
• When analog input is selected: Always lights up.
C: Lights up when the center channel signal comes in.
LS: Lights up when the left rear channel signal comes in.
RS: Lights up when the right rear channel signal comes in.
S:
Lights up when the monaural rear channel signal comes in.
LFE: Lights up when the LFE channel signal comes in.
Note:
When "SUBWOOFER" is set to "YES,"
17).
Selecting different sources for picture and
sound
You can watch picture from a video component while listening to
sound from another component.
Press one of the audio source selecting buttons — PHONO, CD,
CDR, TAPE/MD, USB(AUDIO), FM/AM — while viewing the
picture from a video component such as the VCR or DVD player,
etc.
The lamp on the front panel button for selected source lights up.
*
), the receiver automatically turns
Speaker indicators light up
in white:
L C R
SUBWFR SUBWFR LFE
S
LS RS
lights up (see page
SUBWFR
On the front panel:
DVD MULTI DVD VCR 1 VCR 2
PHONO CD CDR TAPE / MD
SOURCE NAME
From the remote control:
DVD DVD MUILTI
TV/DBS VIDEO CDR
VCR 1 VCR 2 TAPE/MD
Note:
Once you have selected a video source, pictures of the selected
source are sent to the TV until you select another video source.

Adjusting the Volume

On the front panel:
To increase the volume, turn MASTER
VOLUME clockwise.
To decrease the volume, turn it
counterclockwise.
• When you turn MASTER VOLUME rapidly,
the volume level also changes rapidly.
• When you turn MASTER VOLUME slowly,
the volume level also changes slowly.
From the remote control:
To increase the volume, press VOLUME +.
To decrease the volume, press VOLUME –.
CAUTION:
Always set the volume to the minimum before starting any source. If
the volume is set at its high level, the sudden blast of sound energy
can permanently damage your hearing and/or ruin your speakers.
Notes:
• The volume level can be adjusted within the range of "0" (minimum)
to "90" (maximum).
• If you set One Touch Operation to "ON" (see page 21), you do not
have to adjust the volume level each time you change the source. It
is automatically set to the stored level.
VIDEO TV SOUND/DBS
SOURCE NAME
USB AUDIO
FM / AM
CD
FM/AM
PHONO
USB
MASTER VOLUME
+
VOLUME
−
12