Tray Lock Mode; Factory Reset - Yamaha RDX-E700 Service Manual

RDX-E700/NX-E700

TRAY LOCK MODE

In the TRAY LOCK mode, the tray open/close function is
stopped temporarily.
Setting Tray Lock mode
1. With the power turned off, while pressing the "TIMER"
key and "MODE" key, keep pressing the "STANDBY/ON"
key for 4 seconds or longer.
2. When the Tray Lock mode is set, "TRADE ON" is dis-
played which then returns to the normal display.
NOTE 1: Even after the Tray Lock mode is set, all functions
remain the same as usual except the "open/close"
key.
NOTE 2: If no disc is loaded in the tray, the Tray Lock mode
is cancelled automatically.
Canceling Tray Lock mode
1. With the power turned off, while pressing the "TIMER"
key and "MODE" key, keep pressing the "STANDBY/ON"
key for 4 seconds or longer.
2. When the Tray Lock mode is cancelled, "TRADE OFF" is
displayed which then returns to the normal display.

FACTORY RESET

When any of the following conditions applies, perform the
factory reset procedure to make setting of the DVD Mecha-
nism Ass'y suitable for the destination region.
• The DVD Mechanism Ass'y (including MPEG P.C.B.) has
been replaced.
• MPEG P.C.B. has been replaced.
• DVD firmware has been updated.
Operation procedure
1. With the power turned off, while pressing the "SOUND"
key and "MODE" key, keep pressing the "STANDBY/ON"
key for 4 seconds or longer.
2. When the Service Mode is set, the software version in-
formation is displayed on the TV monitor screen con-
nected to the main unit as shown below.
<Example>
At the same time, the host software version is displayed
of the main unit.
<Example>
050824-1
3. Keep pressing the "MODE" key for 4 seconds or longer.
The display unit of the main unit repeats flashing and
then the power is turned off automatically.
This completes the Factory Reset procedure.
12
Region code
TRADE ON
TRADE OFF
050824-1