Camera Installation - Honeywell VSD-261P Operation Manual

2.3 Camera Installation

2.3.1 Ribbon cable：Insert FPC socket of the cable to the relevant port of the base plate on the dome control board.
(Ribbon cable length of 65MM and110MM, user can select the ribbon cable according to the different models of camera)
Figure 4 below illustrates the writing configuration of the ribbon/cable.
2.3.2 Install the camera module: Install the camera module on the vertical axis tray of the dome as illustrated in Fig. 6 and
Fig. 7. Attention: Take care not to scratch the lens when installing the camera. Do make sure the camera model is
the right one for installation. Secure the camera to the corresponding screw holes as illustrated in Fig. 6, according
to the model and make of the camera, as different camera models may have different dimensions. Following the
installation of the camera module verify that it does not touch any of the dome parts including the camera shroud
and acrylic dome by gently moving the camera module along the vertical axis.
FP C
C on n e c to r
F FC
F l e xi bl e F l a t C a bl e
FP C
C on n e c to r
4 -PW M2 *6
Sony camera model screw holes
Honeywell camera model screw holes
Install the camera module on the vertical axis
tray of the dome as illustrated in Fig.7 using the
Fig.6
4 supplied PWM2*6 Screws.
Fig.3
Fig.4
Output of ribbon cable
Fig.5
4
Insert the camera ribbon to the camera
FPC Socket to secure the connection.
Fig.7