Packing - Hitachi C 10FM Technical Data And Service Manual

(5) Cut surface quality during miter cutting
The quality of the cut surface depends on the
type of cutting operation (miter), the type and
sharpness of the saw blade, whether the
workpiece is cut to the right or left. In miter
cutting in particular, cutting is performed across
the wood grain, so the condition of the cut
surface depends on whether the wood is cut
with or against the grain. This is the same as
when using electric portable planers.
Customers should be advised of these
phenomena so that they understand that in
cases when the cut surface may not be as
smooth as expected or hoped for, it is not
caused by the performance of the saw blade or
the Model C 10FM.
In the cutting examples illustrated in Fig. 6, the
cut surfaces on the sides marked
than those on the sides marked

9. PACKING

The main body of the Model C 10 FM is sandwiched between packing (A) and packing (B) made of styrofoam.
This system makes the packaging work easier.
(1) Preparation
Remove the vise ass'y and dust bag from the main unit.
Then swivel the table through 45˚ toward the right.
Fix the table securely with the miter handle.
Push down the head section and insert the locking pin to secure the head section at the lower position.
(2) How to install packing (A)
Put packing (A) in the carton box.
Put the main unit in packing (A).
(3) How to install packing (B)
Put packing (B) on the main unit. Put the vise ass'y and the dust bag in the groove of packing (B).
Close the lids of the carton box and bind them together.
Better
A are better
B .
--- 8 ---
[Miter cutting]
Fig. 6
Better