IQ CCTV IQR4D User Manual page 23

IQCCTV
3.7.1 Alarm
Move the cursor to the 'Alarm' option (the icon is surrounded by a yellow frame to indicate
selection), and press 'Enter' to enter the setup screen of this option, as shown below:
A. I/O CHANNEL/ALARM: Each channel corresponds to an I/O state alarm, when the
alarm input of a channel is valid, the alarm record of the corresponding channel will
be started.

NO: Normally on.

NC: Normally close.

OFF: shutdown alarm of this channel.
B. Note: When an alarm is produced, a red letter 'I' will be displayed above the
corresponding channel.
C. HDD LOSS: On: When the system cannot identify the hard drive, an alarm will be
generated, and a red mark 'H' will be displayed at the bottom left corner of Channel
1 in the lower part of the Video Preview screen.
D. HDD SPACE: On: When the remaining space of the hard drive is less than 500M, the
lower part of the Video Preview screen will display: 'The space of the hard drive is
not enough. Please change the drive after shutdown.'
E. VIDEO LOSS: On: When the video of a certain channel is lost, this channel will
display in the lower part of the Video Preview screen: 'Video Loss'.
F. ALARM MANAGE OUTPUT: the time of the DVR outputting the alarm signal when
an alarm is generated, with the options of 0sec, 10sec, 20sec, 40sec and 60sec.
G. BUZZER: the time of buzzer ringing when an alarm is generated, with the options of
0sec, 10sec, 20sec, 40sec and 60sec.
H. Post Alarm Recording: the time of record delay after the motion detection alarm,
with the options of 30sec, 1min, 2min and 5min
I. Email SETUP: This unit supports motion detection and e-mail alarm.
J. Email setup Prerequisite: The mainframe must be connected to the WAN. See
Chapter 4 'DVR Network' for the connection method.
K. When motion detection is triggered, the system will extract a picture at the time of
triggering and send it to the corresponding mailbox.
IQR4D – 4 Camera DVR