Toshiba MMU-AP0091H Owner's Manual page 10

Super heat recovery multi, indoor/outdoor unit, 1-way / 2-way / 4-way air discharge cassette type, floor standing cabinet type, for commercial use
Hide thumbs Also See for MMU-AP0091H:
Table of Contents

Advertisement

Available languages
  • EN

Available languages

  • ENGLISH, page 4
Operation section
Push each button to select a desired operation.
This remote controller can operate the maximum 8 indoor units.
• The details of the operation needs to be set up once, afterward, the air conditioner can be used by pushing
button only.
2
3
4
5
1
Air volume select button
Selects the desired air volume mode.
The Concealed Duct High Static Pressure type
models cannot be operated.
2
Timer set button
TIMER SET button is used when the timer is
set up.
3
Check button
The CHECK button is used for the check
operation. During normal operation, do not
use this button.
4
Fan button
FAN button is used when a fan which is sold on
the market or etc. is connected.
• If
is displayed on the remote controller
when pushing the FAN button, a fan is not
connected.
5
Filter reset button
Resets (Erases) "FILTER
6
Wind direction and Swing
:
UNIT
If the multiple indoor units are operated by only
one remote controller, select the units when
the air direction is adjusted.
:
Set up the auto swing and angle of the flap.
• This function is not provided to Concealed
Duct Standard Type, High Static Pressure
Type, Floor standing Cabinet Type, or Floor
Standing Concealed Type.
1
7
UNIT
SET
CL
6
7
8
9
10
" display.
Remote controller sensor
Usually the TEMP . sensor of the indoor unit senses
the temperature. The temperature on the surround-
ing of the remote controller can also be sensed.
For details, contact the dealer from which you have
purchased the air conditioner.
• In case that one remote controller controls the
7
Operation lamp
Lamp is lit during the operation. Lamp is off
when stopped.
Although it flashes when operating the protec-
tion device or abnormal time.
button
When the button is pushed, the operation
starts, and it stops by pushing the button
again.
When the operation has stopped, the operation
lamp and all the displays disappear.
Operation select button
Selects desired operation mode.
Set up temperature button
Adjusts the room temperature.
Set the desired set temperature by pushing
or
multiple indoor units, the setup operation is
unavailable in group control.
8
9
10
.

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents