Number Buttons - LG 32FS2AMB Service Manual

11. Deflection setting initial data
ITEM Range
VL 0 ~ FFFF
VA 0 ~ FFFF
SC 0 ~ FFFF
VS 0 ~ FFFF
HS 0 ~ FFFF
EW 0 ~ FFFF
ET 0 ~ FFFF
EP 0 ~ FFFF
CRNU 0 ~ FFFF
CRNL 0 ~ FFFF
BOW 0 ~ FFFF
ANGLE 0 ~ FFFF
CRNU6 0 ~ FFFF
CRNL6 0 ~ FFFF
* Check adjustment condition at 1080i/50Hz, NTSC60Hz after
finishing adjustment in PAL100Hz, adjust defection
adjustment at each Mode again.
* Sequence
:PAL 100Hz(RF)
1080i/50Hz(COMPONENT)
12. How to inspect condition of a
transmission and reception in
wireless sound model(option)
- Wireless sound model's efficiency inspections is executed to a
finished in a final inspection phase.
- Wireless sound is a function which receives voice-signal by an
exclusive remote control and Earphone, transmits a FM
through transmitter of inner part in MICOM BOARD to TV
sound(MONITOR OUTPUT)
1) Execute in channel generating voice-signal
2) Select a transmitted frequency in MENU OSD.
3) A received frequency in an exclusive remote control or
received FM Radio is tuned by 87.7MHz which is same as
frequency in OSD.
4) Check out whether a signal generating to MAIN SPEAKER
generates in earphone or receiver or not.
5) There is no alternation and setting of adjusted DATA in the
process of inspecting FM TX.
RF PAL
RF NTSC
1080i/50
100Hz 1080i/50
FFFC FFF3 FFDD
004E 0014 002A
009E 009E 007C
FFF8 FF10 0003
005D 005E 005C
0044 0041 006C
FFFB FFDE FFC0
FFD0 FEE2 FE94
0004 0004 FFF6
000B 0025 002A
000B
0007 0007
000A 0009 0009
0056 003A 0056
003F 0030 0042
-> NTSC 60Hz(RF)
13. OPTION setting
13-2. Preliminary steps
1) This option adjustment decides function in accordance with
model. Press the SVC TX adjustment button(CH up/down
button) at SVC mode, then adjust the option at OPTION1, 2,
3, 4, 5 mode.
2) Mark the option adjustment data like [111,111,111,111,111]
in BOM.
OPTION 1
OPTION 2
OPTION 3
OPTION 4
OPTION 5
* Mark of BOM
LEVEL PART NO.
1. 3141VMNxxxA MAIN CHASSIS ASSY
In this model, the OPTION1 data is 091, OPTION2 data is 016, the OPTION3
data is 143,the OPTION 4 data is 100, OPTION 5 data is 000.
->
13-2. Adjustment Method
1) Input OPTION value with number button on remote control at
each OPTION adjustment mode.
2) At each OPTION Mode, Select adjustment item by the CH
E
button and then set up each OPTION by the
OP [113,63,112,201,248]
SPECIFICATION DESCRIPTION
OPT[091,016,143,100,000]
D
,
F G
, button.