Table of Contents
Advertisement
Operating Your Camera
Notes
• T he chance of resolution decrease is existed because DIS function uses the digital zoom.
• D IS doesn't operate when background illumination is too low.
• D IS doesn't operate when object pattern is monotonic as like sky or white wall.
• I f Digital Image Stabilizer (DIS) is enabled, the digital zoom is not configured to less than
46 level.
COMM ADJ (Communication Adjustment):
This function sets up the camera communication
status when controlling the camera through an
external control device.
... ... ... When the SPECIAL menu screen is displayed,
press the Function Setup switch so that the arrow
indicates 'COMM ADJ'.
... ... ... Set up the mode using the Function Setup switch.
- CAM ID : Determines the camera's identification number (between 0 and 25).
- BAUD RATE : You can select 2400/4800/9600/19200/38400/57600 bps.
- UART MODE : You can select NONE, EVEN or ODD for the parity bits.
- RET PKT : D etermines whether to send a command back to the controller
device when a communication control command is sent to the
camera.
- DISP CAM ID : Display camera title on top left corner of the screen.
LANGUAGE : You can select the menu language according to your
requirements.
RESET : Resets the camera settings to the factory defaults.
RETURN : Select this to save the SPECIAL menu settings and return to the MAIN SETUP
menu.
EXIT
Press the Function Setup switch in the EXIT menu to save the current settings and exit the
MAIN SETUP menu.
28
COLOR DOME CAMERA
User's Manual
Troubleshooting
Refer to the following table if you are experiencing trouble with your camera.
Contact an authorized technician if the table does not provide you with a
solution to the trouble.
● Nothing appears on the screen.
▶
Check that the power cord and line connection between the camera and monitor are fixed properly.
▶ Check that you have properly connected VIDEO cable to the camera VIDEO output jack.
● The image on the screen is dim.
Is lens stained with dirt? Clean your lens with soft, clean cloth.
▶
▶ Set the monitor or DVR to proper condition.
If the camera is exposed to too strong light, change the camera position.
▶
● The image on the screen is dark.
▶ Adjust the contrast feature of the monitor or DVR.
▶ I f you have an intermediate device, set the 75Ω / Hi-z properly.
● The camera is not working properly, and the surface of the camera is hot.
Check that you have properly connected the camera to an appropriate power source.
▶
● The DAY/NIGHT menu does not work.
▶ Check that AGC of EXPOSURE SETUP menu is 'OFF'.
● The SENS-UP function does not work.
▶ Check that AGC of EXPOSURE SETUP menu is 'OFF'.
▶ Check that SHUTTER of EXPOSURE SETUP menu is 'A.FLK'.
● The Motion Detection function does not work.
▶ Check that MOTION DEF of SPECIAL SETUP menu is 'OFF'.
● Color is not correct.
▶ Check the setting of WHITE BAL SETUP menu .
● The screen flickers continually.
▶
Check that direction of camera turns toward the Sun.
● RS-485 communication fails.
▶ Check the polarity between RS-485 Control Port and RS-485 cable.
485 Control Board Connection Port
RS-485 Control Port
(+) CONNECTION TERMINAL (TRX+)
( - ) CONNECTION TERMINAL (TRX-)
▶ Check the RS-485 Communication establishment initial value
* RS-485 Communication establishment initial value
Item
Camera ID
BAUD RATE
UART MODE
Initial value
1
9600
8-NONE-1
▶ W e recommend that you make ground connect between camera and controller in order to maintain
safety communication control.
COLOR DOME CAMERA
485+
485-
RET PKT
ENABLE
29
User's Manual
Advertisement
Table of Contents
