Honeywell CO48PM Owner's Manual page 16

CLEANING & MAINTENANCE
Draining and Cleaning The Water Tank
• Turn the power OFF and disconnect the air cooler from the power supply.
• Move the unit to a location where it can be drained.
• Remove the drain plug and allow the tank to empty (#12 on Page 8).
• Refill the water tank to maximum level with clean water and drain
it completely.
• Fill the water tank and rinse at least 2-3 times before use.
After cleaning ensure that the drain plug is back in place.
Plug into the power supply and turn on the unit.
Cleaning The Honeycomb Cooling Media
• Turn off the unit, and unplug the power cord from wall
outlet.
• Rotate the unit facing the back panel, and locate the the Rear
Panel of the unit.
• Grill Removal Screws (#15 on Page 8) - Remove the 6 screws
with a screw driver.
• Pull the rear grill panel until it is completely removed.
The cooler has Honeycomb Cooling Media on the right and
left panels. The cleaning and removal procedure is the same
as the Rear Panel.
• The Honeycomb Cooling Media can now be seen. Clean it
with a clean cloth to remove all the dust & dirt particles.
• Once cleaning is finished, reassemble the unit.
14
Water Drain
Plug
Rear Panel
Open Screws