Cool Mode; Dry Mode; Heat Mode; Emergency Operation - Mitsubishi Electric MSZ-FB25VA Operating Instructions Manual

Split-type air conditioners
Table of Contents

Advertisement

● OPERATING INSTRUCTIONS ●
S
ELECTING OPERATION MODES
1
Press
to start the operation.
2
Press
to select operation mode. Each press
changes mode in the following order:
(AUTO)
(COOL)
3
Press or to set the temperature.
Each press raises or lowers the temperature by 1°C.
Press
to stop the operation.
• The same setting is selected the next time by simply pressing
Multi system operation
Two or more indoor units can be operated by one outdoor unit. When several
indoor units are operated simultaneously, cooling and heating operations can-
not be done at the same time. When COOL is selected with one unit and HEAT
with another or vice versa, the unit operated later becomes standby mode. The
power lamp blinks (display section).
En-5
(DRY)
(HEAT)
.
AUTO mode (Auto change over)
The unit selects the operation mode according to the difference between the
room temperature and the set temperature. During AUTO mode, the unit
changes mode (COOL↔HEAT) when the room temperature is 2°C away
from the set temperature for more than 15 minutes.
Note:
Multi system operation
Two or more indoor units can be operated by one outdoor unit. When sev-
eral indoor units are operated simultaneously, the unit may not be able to
switch operation mode between COOL and HEAT. In this case, the indoor
unit becomes standby mode.

COOL mode

Enjoy cool air at your desired temperature.
Note:
Do not operate COOL mode at very low outside temperatures (less than
-10°C). Water condensed in the unit may drip and wet or damage furni-
ture, etc.

DRY mode

Dehumidify your room. The room may be cooled slightly.
Temperature cannot be set during DRY mode.

HEAT mode

Enjoy warm air at your desired temperature.

Emergency operation

When the remote controller cannot be used...
Emergency operation can be activated by pressing the emergency operation
switch (E.O.SW) on the indoor unit.
Each time the E.O.SW is pressed, the operation changes in
the following order:
Operation indicator lamp
Note:
The fi rst 30 minutes of operation is test run. Temperature
control does not work, and fan speed is set to High.

Auto restart function

If a power failure occurs or the main power is turned off during operation, "Auto
restart function" automatically starts operation in the same mode as the one set
with the remote controller just before the shutoff of the main power. When
timer is set, timer setting is cancelled and the unit starts operation when power
is resumed.
If you do not want to use this function, please consult the service repre-
sentative because the setting of the unit needs to be changed.
Emergency COOL
Emergency HEAT
Set temperature : 24°C
Stop
Fan speed : Medium
Horizontal vane : Auto

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

Msz-fb35vaMsz-fb50va

Table of Contents