Table of Contents
Advertisement
Recording Features
Copying your Tapes to
S-VHS or VHS Cassette
Source (Playing)
unit
DC Cable
(Supplied)
A/V Cable
(Supplied)
S-Video
Cable (not
supplied)
To Audio In
To Video In
To S-Video In
(If there is S-Video In)
Monitor with your TV
• Turn the TV ON and select its VCR
channel (either CH3 or CH4).
• Set the VCR/TV Selector on the
recording VCR to VCR.
22
S-VIDEO OUT
A/V OUT
TV
(To View)
VHF Connecting
Cable (not
supplied)
Recording:
VCR (Rear)
Audio In
Video In
S-Video In
Before you begin
• Connect this unit and VCR to their
power sources.
• Connect this unit to a VCR as illustrated
left.
• Turn ON both units.
• Set the recording VCR's Input Signal
Selector to LINE.
• Before using S-VIDEO Connector,
insert the DC Cable into the DC IN
Terminal. (p. 10)
1
Insert a pre-recorded tape
into the source (playing) unit and a
blank tape, with record tab in place,
into the target VCR (Recorder).
2
Press MENU to display the MAIN
MENU screen.
3
Press +/– to select
press SET to display the REC MODE
menu screen.
4
Press +/– to select
press SET to select OUT/PHONES.
• Press MENU twice to exit.
• "DV IN" will appear on the screen.
5
Press
(PLAY) on this unit. When the
tape reaches the point from which you
want to start dubbing, press PAUSE.
6
Place the VCR into REC/PAUSE
mode. (See VCR manual.)
7
Simultaneously, press PAUSE on
both units to begin copying.
8
Press STOP on both units when
copying is completed.
Note
• For technical reasons, dubbing a tape
may reduce its quality.
• If the Time Code is displayed in the LCD
monitor, it cannot be reset.
• Only the DATE/TIME, when displayed,
will be recorded on the tape.
CAUTION:
Unauthorized exchanging and/or
copying of copyrighted recordings may
be copyright infringement.
REC MODE
, then
AV JACK
, then
Advertisement
Table of Contents
