Water Outlet Hose Connection - Zanussi DE 4744 Instruction Book

Dishwasher
Hide thumbs Also See for DE 4744:
Table of Contents

Advertisement

Water outlet hose connection

The end of the drain hose can be connected in the
following ways:
1. To the sink outlet spigot, securing it if necessary
with a clip.
2. Hooked over the edge of the sink using the special
curved plastic guide provided.
3. To a stand pipe provided with vent-hole, minimum
internal diameter 4 cm.
The waste connection must be at a height of between
30 cm (minimum) and 100 cm (maximum) from the
bottom of the dishwasher.
The drain hose can face either to the right or left of the
dishwasher
Ensure the hose is not bent or squashed as this could
prevent or slow down the discharge of water.
The sink plug must not be in place when the
machine is draining as this could cause the water
to siphon back into the machine.
If you use a drain hose extension it must be no longer
than 2 metres and its internal diameter must be no
smaller than the diameter of the hose provided.
Likewise the internal diameter of the couplings used
for connections to the waste outlet must be no smaller
than the diameter of the hose provided.
Attention!
Our appliances are supplied with a
security device to protect against the
return of dirty water back into the
machine.
If the spigot of your sink has a "no return
valve" incorporated this can prevent the
correct draining of your dishwasher.
We advise you therefore to remove it.
1
CS13
CS14
24
2
+ 2 m max

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents