Mitsubishi Electric XD206U User Manual page 16

Hide thumbs Also See for XD206U:
Table of Contents

Advertisement

Menu operation (continued)
1 IMAGE
CONTRAST ................................................Use to adjust the image contrast. The contrast becomes
BRIGHTNESS.............................................Use to adjust the image brightness. The image becomes
WHITE ENHANCE......................................Use to adjust the white level of the projected image.
COLOR TEMP ............................................Use to adjust the color temperature. See page 18.
COLOR .......................................................Use to adjust the color intensity of the image.
TINT ............................................................Use to adjust the color balance of the image. The color
SHARPNESS..............................................Use to adjust the image sharpness. The image becomes sharp as the value increases. (Not available
GAMMA MODE ..........................................When AUTO is selected, the appropriate gamma mode is automatically selected depending on the
2 INSTALLATION
AUTO POWER ON .....................................When ON is chosen, the lamp is automatically lit when
AUTO POWER OFF....................................Use to set the time elapsed before the projector enters
SPLASH SCREEN......................................Choose ON to display the splash screen when the power
BACK COLOR.............................................Use to select the background from among BLUE and BLACK, which will be displayed when there is
LAMP MODE ..............................................Use to change the brightness of the lamp. When LOW is chosen, the lamp brightness is kept low and
IMAGE REVERSE ......................................Use to reverse the projected image. Select MIRROR for rear projection with the tabletop-mounted
LAMP TIME.................................................The duration of illumination of a lamp converted in the Low mode is displayed.
EN-16
higher as the value increases.
brighter as the value increases.
balance shifts to purple as the value increases and shifts
to green as the value decreases. (Available only when
VIDEO or S-VIDEO is chosen as the source.)
When the TV50 (PAL, SECAM) signal is input, TINT
can't be adjusted.
with certain signals.)
input signal. For normal use, select AUTO. Select DYNAMIC for computer sources. Select STAN-
DARD for sport scenes and video sources. Select THEATER for film sources.
the power cord is plugged in the wall outlet. When
changing ON/OFF, this setting is saved after cooling
down. (In case of Instant Shut Down, this setting is not
saved.) Choose ON when using the projector mounted
on the ceiling.
The projector is in the stand-by mode when the lamp
is off. Use the remote control to turn on the lamp.
the stand-by mode when there is no signal input from the
source.
is turned on.
no signal input from the source.
the projector operating noise is reduced, resulting in a longer lamp replacement interval.
When the lamp mode is switched, the projected image may flicker. This is not a product malfunc-
tion.
Do not change the setting of LAMP MODE frequently.
When LAMP MODE has been set to LOW, the lamp mode changes from STANDARD to LOW
about one minute after turn on.
projector. Select MIRROR INVERT for front projection with the ceiling-mounted projector.
opt.
XGA60
IMAGE
CONTRAST
BRIGHTNESS
WHITE ENHANCE
COLOR TEMP.
STANDARD
COLOR
TINT
SHARPNESS
GAMMA MODE
STANDARD
opt.
XGA60
INSTALLATION
AUTO POWER ON
OFF
AUTO POWER OFF
OFF
SPLASH SCREEN
ON
ON
BACK COLOR
BLUE
STANDARD
LAMP MODE
IMAGE REVERSE
OFF
LAMP TIME
0
0
10
0
0
0
0

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

Xd206u-g

Table of Contents