Adjusting The Lcd During Play; Controlling Sound From The Speaker - Samsung SCD24 Owner's Instruction Book

ENGLISH
Basic Recording

Adjusting the LCD during PLAY

You can adjust the LCD during playback.
The adjustment method is the same procedure as used in CAMERA mode. (see page 31)

Controlling Sound from the Speaker

The Speaker works in PLAYER mode only.
When you use the LCD screen for playback, you can hear the recorded sound from
the built-in Speaker.
- Follow the instructions below to decrease or mute speaker volume in the PLAYER mode.
- Take the following steps to lower the volume or mute the sound while playing a tape
on the camcorder.
1. Set the power switch to PLAYER mode.
2. Press (PLAY/STILL) to play the tape.
3. When you hear sounds once the tape is in play, use the MENU DIAL to adjust the volume.
A volume level display will appear on the LCD.
Levels may be adjusted from anywhere between 00 to 19 and you will not hear
any sound when the volume is set on 00.
If you close the LCD while playing, you will not hear sound from the speaker.
Notes
When the cable is connected to the A/V jack, you cannot hear sound from the camcorder
speaker and cannot adjust the volume.
You can hear sound from camcorder speaker by removing the connected cable
from the A/V jack
34 34
VOL / MF
<3-2>
0 : 2 3 : 4 7
5 5 min
VOL. [ 1 1 ]
1 0 : 0 0 AM
J A N . 1 0 , 2 0 0 3