Advertisement
Replacement Procedure
(10) Replacement of PCB (strength pulse)
1, Disconnect the connector CN931 of the PCB
(strength pulse).
2, Remove one PCB (strength pulse) set screw
and take off the PCB (strength pulse).
PCB (strength pulse)
PCB set screw
Belt(strength)
(11) Replacement of Motor (strength)
1, Remove each cord processing.
2, Remove two stay (under the motor (strength))
set screws. Photo-24
3, Disconnect the belt (strength).
4, Remove two motor (strength) set screws and
take off the motor (strength) and the stay
(under the motor (strength)).
5, Remove two motor (strength) set screws and
take off the motor (strength).
* Exercise care so as not to adhere grease to
the driving portions such as belt
(Failure to observe this precaution may lead
to malfunction due to slippage).
Stay (under the Motor (strength))
Photo-23
Photo-23
Motor set screws
Motor (strength)
Photo-23
Photo-23
Photo-23, 24
Motor (strength)
Stay set screw
Photo-24
(12) Replacement of PCB (Massage)
1, Disconnect five PCB (massage) connectors.
2, Remove two PCB (massage) set screws and
take off the PCB (massage).
Motor set screws
Motor (massage)
(13) Replacement of Motor (Massage)
1, Remove each cord processing.
2, Disconnect the belt (massage).
3, Remove two motor (massage) set screws.
4, Remove two stay (under the motor (massage))
set screws and take off the motor (massage).
and the stay (under the motor (massage)).
5, Remove one motor (massage) set screw and take
off the motor (massage).
* Exercise care so as not to adhere grease to
the driving portions such as belt (Failure to
observe this precaution may lead to
malfunction due to slippage).
Motor (massage)
Motor set screw
Stay (under the massage motor)
- 27 -
HEC-DR5000
Belt (massage)
PCB set screw
PCB (massage pulse)
Photo-25
Stay set screw
Photo-26
(GENERAL)
Photo-25
Photo-25
Photo-25
Photo-25
Photo-26
Photo-26
Advertisement
