Replacement Procedure - Sanyo HEC-DR5000 Service Manual

Replacement Procedure

(1) Replacement of PCBs (main)
& (power)
1, Take off four thread caps on an arm rest
(left).
2, Remove four set screws on the elbow rest
and take off the arm rest (left).
Arm rest (left)
Arm rest set screws
3, Lift up a foot rest and insert a screwdriver
and so forth into a link to fix the link.
4, Remove four cover (under front) set screws
and take off the cover (under front).
Driver, etc
Cover set screws
Photo-1
Photo-1
Thread caps
Photo-1
Photo-2
Photo-2
Cover (under front)
Photo-2
5, Remove two cover (PCB) set screws and take
off latches of ribs at the rear of the cover.
Cover (PCB) set screws
6, Disconnect connectors connected to the
PCB (power).
7, Unfix seven stoppers (PCB) and take off the
PCB (power).
8, Remove three stay (PCB) set screws and
take off the stay (PCB).
* There is a set screw around under a reclining
motor at the left side.
9, Disconnect the connectors connected to the
PCB (main).
10, Unfix nine stoppers (PCB) from the bottom
side of the massager and take off the
PCB (main).
PCB (main)
Stay (PCB) set screws
- 21 -
HEC-DR5000
(GENERAL)
Photo-3
Cover (PCB)
Photo-3
Photo-4
Photo-4
Photo-4
Photo-4
Photo-4
PCB (power)
Stoppers
Photo-4