Assembly; Fitting The Loop Handle; Assembling And Dismantling The Two-Piece Shaft; Fitting The Trimmer Head - Husqvarna 323C Operator's Manual

Fitting the loop handle

(323C, 325Cx)
• Position the handle on the shaft. Note that the handle
must be mounted below the arrow on the shaft.
• Fit the screw, securing plate and wing nut as shown in the
diagram.
• Tighten the wing nut.
Fitting the loop handle
(323L, 323LD, 325Lx, 325LDx)
• Clip the loop handle onto the shaft. Note that the loop
handle must be fitted between the arrows on the shaft.
• Slide the spacer into the slot in the loop handle.
• 323L/323LD: Fit the nut, washer and screw.
325Lx/325LDx: Fit the nut, knob and screw. Do not
overtighten.
• Now adjust the trimmer to give a comfortable working
position. Tighten the bolt/knob.
Assembling and dismantling the
two-piece shaft
(323LD, 325LDx)

Assembly:

• Make sure the knob is loose.
10 –
English
ASSEMBLY
• Align the cut-out in the lower part of the shaft with the
coupling locking tab on the upper part of the shaft. Then
lock the sections together.
• Tighten the knob.
Dismantling:
• Undo the knob (at least three turns).
• Push the knob towards the coupling.
• Carefully twist the lower half of the shaft to unlock it.
• Hold both parts of the shaft and pull the lower part of the
shaft out of the coupling.

Fitting the trimmer head

When fitting the cutting attachment it is extremely important
that the raised section on the drive disc/support flange
engages correctly in the centre hole of the cutting attachment.
If the cutting attachment is fitted incorrectly it can result in
serious and/or fatal personal injury.
!
WARNING! Never use a cutting attachment
without an approved guard. See the chapter
on Technical data. If an incorrect or faulty
guard is fitted this can cause serious
personal injury.