Corrosion Protection - Honda 2003 Pilot Owner's Manual

Main Menu
Table of Contents
Two factors normally contribute to
causing corrosion in your vehicle:
1. Moisture trapped in body cavities.
Dirt and road salt that collects in
hollows on the underside of the
vehicle stays damp, promoting
corrosion in that area.
2. Removal of paint and protective
coatings from the exterior and
underside of the vehicle.
Many corrosion-preventive measures
are built into your Honda. You can
help keep your vehicle from
corroding by performing some
simple periodic maintenance:
Repair chips and scratches in the
paint as soon as you discover them.
Inspect and clean out the drain
holes in the bottom of the doors
and body.
Check the floor coverings for
dampness. Carpeting and floor
mats may remain damp for a long
time, especially in winter. This
dampness can eventually cause
the floor panels to corrode.

Corrosion Protection

Use a high-pressure spray to clean
the underside of your vehicle. This
is especially important in areas
that use road salt in winter. It is
also a good idea in humid climates
and areas subject to salt air. Be
careful of the ABS wheel sensors
and wiring at each wheel.
Have the corrosion-preventive
coatings on the underside of your
vehicle inspected and repaired
periodically.
Appearance Care
331