Operating Information - Invacare BAR750 Owner's Operating And Maintenance Manual

SECTION 1—GENERAL GUIDELINES

Operating Information

Check all parts for shipping damage and test before using. In case of damage, DO NOT
use. Contact a qualified technician for further instruction.
After any adjustments, repair or service and before use, make sure all attaching hardware
is tightened securely.
Close supervision is necessary when the electric bed is used by or near children and
physically challenged individuals.
DO NOT let any individual underneath the bed or in between the raised bed frame
components at anytime.
When bed is not to be used for an extended period, unplug electric bed from the wall
outlet.
Keep the product a minimum of 12 inches away from any direct heat source.
DO NOT unplug power cord from junction box.
If a liquid is spilled in or around the electric bed, unplug the electric bed before cleaning.
Clean up the spill and allow the electric bed or the area around the electric bed to dry
thoroughly before using the electric controls again.
The electric bed is not designed to be used as a patient transport. When transporting a
patient, use an approved patient transport. Otherwise, injury or damage may result.
When operating/moving electric beds, ALWAYS ensure that the individual utilizing the
bed is positioned properly within the confines of the bed. DO NOT let any extremities
protrude over the side or between the bed rails when performing these functions.
After the electric bed has been assembled, ALWAYS test to make sure that all sections of
the electric bed are properly and securely in place before using.
Make sure head and foot springs/sections are connected securely to the universal bed
ends before use.
NEVER operate the unit if these cords are damaged.
If the unit is not working properly, call a qualified technician to examine the unit and
repair it.
Keep all moving parts, including the main frame, mattress deck (head and foot
springs/sections) and all drive shafts, free of obstruction (i.e. blankets/sheets, heating
blankets/pads, tubing, wiring, etc. and other types of products using electric cords which
may get tangled around the bed, bed rails or legs) during operation of the electric bed.
The electric bed is equipped with locking casters. When transferring into or out of the
electric bed, ALWAYS lock the locking caster(s). Inspect the wheel locks for correct
locking action before actual use. Even with casters properly locked, some flooring
surfaces such as tile or wood, will allow the bed to move under some conditions. Use on
surfaces such as these MUST be evaluated by the care provider.
Ensure that all four casters are locked and that the bed does not move before transferring.
DO NOT transfer occupant if bed is not stable.
11
Part No 1143215 BAR750