Handset Cord; Line Cord; Recommendation For Installation - Siemens euroset 3020 User Manual

Hide thumbs Also See for euroset 3020:
Table of Contents

Advertisement

power fault occurs, the telephone will not
be supplied by the power supply.
To install or replace the batteries, follow the
steps below:
• disconnect
the
equipment
telephone line.
• open the battery compartment (position
30).
• install four new batteries, taking care to
observe the correct position (polarity
indicated by the drawing inside the
compartment).
When the batteries are low, needing to be
changed, the display will show the low
battery indicator symbol (position 27 on
page 3).
To install the power supply, just connect it
to the telephone (position 18 on page 3)
and to the electric energy network plug.
34
30
Note:
• The telephone operates without batteries
or without a power supply to carry out
calls, but the call identification will not
work and the display can switch off.
• When a power supply is used with the
telephone, it is recommended to use the
C39280-Z4-C508 Siemens power supply.

Handset cord

Connect the long end of the handset cord in
the socket marked with the symbol
(position 31). Insert the cord in the cable
line (position 32) and attach the short end
from
the
to the handset.

Line cord

Connect the line cord in the socket marked
with the symbol
cord in the cable line (position 34). Attach
the other end to the telephone line (RJ11
modular Jack connector).

Recommendation for Installation

Please, observe the following guidelines:
• For your own safety and protection, do
not uses the telephone in places with
overheat
or
telephone
operates
between +5ºC and +55ºC and it is not
water-proof.
31
• Varnished or lacquered furniture may be
32
marked by some parts of the telephone
such as the rubber feet.
• Place the telephone at least one meter
33
away from devices such as cordless
telephones or TV sets. These devices
may cause interference in the telephone.
• To clean the telephone, just use a damp
or antistatic cloth. Never use a dry cloth
(danger of electrostatic discharge) or any
abrasive cleaning products.
• When the telephone reaches its end of
service life, dispose of it in a way that
does
not cause any harm
environment, in accordance with the local
legal requirements.
• Please, dispose of used batteries in
accordance
environment protection.
4
(position 33). Insert the
extreme
humidity.
The
at
temperatures
to the
with
requirements
of

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents