Adjusting the LCD during PLAY
✤ You can adjust the LCD during playback.
✤ The adjustment method is the same procedure as used in CAMERA
mode. (see page 32)
Controlling Sound from the Speaker
The Speaker works in PLAYER mode only.
When you use the LCD screen for playback, you can hear recorded sound
from the built-in Speaker.
Follow the instructions below to decrease or mute
speaker volume in the PLAYER mode.
Take the following steps to lower the volume or mute
the sound while playing a tape on the camcorder.
1. Set the power switch to PLAYER mode.
(PLAY/STILL) to play the tape.
3. When you hear sounds once the tape is in play,
use the MENU SELECTOR to adjust the volume.
A volume level display will appear on the LCD.
Levels may be adjusted from anywhere between
00 to 19 and you will not hear any sound when the
volume is set on 00.
If you close the LCD while playing, you will not hear
sound from the speaker.
When the cable is connected to the Multi-AV jack, you
cannot hear sound from the speaker and cannot adjust the
If a cable is connected to the Multi-AV jack, you can hear
sound from the speaker when AV IN/OUT MODE on
MENU is set to AV IN. (VP-D323i/D325i/D327i only)
0 : 2 3 : 4 7
5 5 min
[ 1 1 ]
1 2 : 0 0
1 0 . J A N . 2 0 0 4
S-VIDEO IN S-
AV IN/OUT MODE