Troubleshooting - Philips FW-V39 User Manual

Vcd mini hi-fi system video cd version 2.0
Hide thumbs Also See for FW-V39:
Table of Contents

Advertisement

TROUBLESHOOTING

General
System does not react when any
button is pressed.
• Electrostatic discharge.
™ Press STANDBY ON to switch the
system off. Remove the AC power plug
from the wall outlet, then reconnect the
power plug and switch on the system
again.
No or poor sound.
• Volume is not turned up.
™ Adjust VOLUME.
• The headphones are connected.
™ Disconnect the headphones.
• Speakers are not connected or are
connected wrongly.
™ Check that the speakers are connected
correctly.
™ Make sure the stripped speaker wire is
clamped.
• The MP3-CD bit rate below 32 kbps.
™ Make sure the MP3-CD was recorded
within 32-256 kbps bit rate with
sampling frequencies at 48 kHz,
44.1 kHz or 32 kHz.
Reversed left and right sound.
• Speakers are connected wrongly.
™ Check the speaker connections and
location.
28
pg 01-28/V39/21-En
28
Lack of bass sound or apparently
imprecise physical location of musical
instruments.
• Speakers are connected wrongly.
™ Check the speaker connection for
proper phasing, colored/black wires to
colored/black terminals.
Remote control has no effect on the
system.
• Wrong source is selected.
™ Select the source (VCD, TUNER, etc.)
before pressing the function button,
( É , í , ë , etc.).
• The distance to the system is too large.
™ Reduce the distance.
• Batteries are inserted incorrectly.
™ Insert the batteries with their polarities
(+/– signs) as indicated.
• Batteries are exhausted.
™ Replace the batteries.
Timer is not working.
• Clock is not set.
™ Set the clock.
• Timer is not switched on.
™ Press CLOCK•TIMER to switch on the
timer.
• Recording is in progress.
™ Stop recording.
Clock setting is erased.
• There was a power failure.
™ Reset the clock.
System displays features
automatically; buttons flash
continuously.
• Demonstration mode is switched on.
™ Press and hold Ç (on the system only)
for 5 seconds to switch off the
demonstration.
All lighted buttons are not lit.
• Display is switch on in DIM 3 mode.
™ Press DIM until DIM OFF display mode
is shown.
6/8/01, 9:02 AM
3139 116 19982

Advertisement

Table of Contents
loading

Table of Contents