Manual Audio Control - Philips DVD Video Recorder Manual

Hide thumbs

Table of Contents

01DVDR980UMUKGB24271F3

21-01-2002

VOL

MUTE

T/C

The following programme numbers are provided for

recording from external sources:

'EXT1' : TV set via

'EXT2' : for recording from external sources via

SCART

'EXT3' : rear S-video

'EXT4' : rear CVBS

'CAM1' : front S-video (Y/C)

'CAM2' : front Video (CVBS)

l Press RECORD (on the recorder) or REC/OTR

(on the remote control).

‰

is shown on the display.

RECORD

‰ The status box is shown on the screen for a few

seconds.

l To bring back the status box during recording press

SYSTEM MENU. Pressing SYSTEM MENU once

more will remove the status box again.

l Press ; PAUSE to pause recording. You can

resume recording by pressing ; PAUSE once more.

The DVD recorder will make a seamless connection.

l Press 9 STOP to stop recording. If you are recording

from a camcorder watch the video output of the

DVD recorder on the TV - instead of the camcorder

viewer - to determine the right moment to stop.

15:24

Pagina 29

MONITOR

ON/OFF

REC/OTR

REVERSE

PAUSE

SLOW

FORWARD

STOP

FSS

PLAY

A/CH

socket

SCART

socket

l The Index Picture Screen is updated.

‰ 'MENU UPDATE' is shown on the display.

l After a short recording on a new DVD+RW disc, a

few minutes will be needed to complete the

formatting of the disc.

Safe Recording

When you start recording on a DVD+RW disc by briefly

pressing the RECORD or REC/OTR key, a recording

on DVD+RW will be made from the current position of

the disc pointer. To prevent this do the following:

l Hold the RECORD key (on the recorder) or

REC/OTR key (on the remote control) press for

about two seconds until 'SAFE RECORD' appears

on the display.

l The recorder automatically jumps to the end of the

last title on the disc and starts recording.

‰ If no free space is left. The display will show

'DISC FULL'. Safe record is not possible then.

Recordings on DVD+RW are always automatically made

after the last title on the disc.

Direct Record

With Direct Record you can start recording immediately

from the programme selected on the TV set.

l Make sure 'Direct record' is switched 'On'.

(See record settings).

l On the TV set, select the programme number you

want make the recording from.

l Make sure the DVD recorder is switched to

standby.

l Press RECORD (on the recorder) or REC/OTR

(on the remote control).

Notes :

- Don't select another programme number on your TV set,

until the 'WAIT' on the display of your DVD recorder

disappears. This can take up to one minute.

- When 'NOTV' appears on the display, the programme

number could not be found. The DVD recorder switches off

automatically.

- If your loudspeakers are connected (via an amplifier /

receiver) to your DVD recorder, the sound will be delayed

relative to the TV picture when recording directly from the TV

set.

- You can use Direct Record in combination with Safe Record.