Dock Phone In Charger - Cisco 7925G User Manual

Dock Phone in Charger

Procedure
Step 1 Insert the phone into the charger and turn on the phone.
Step 2 Press and hold the Control button on the side of the charger for 5 seconds.
The Power/Bluetooth Status LED flashes and the charger enters pairing mode.
Step 3
On the phone, choose
Step 4 If the first item in the Bluetooth menu displays Bluetooth Disabled, press Select, select Enable, and
press Save.
Step 5 Choose Device List.
Step 6 Press Scan.
A list of devices appears. The scan may take a few seconds to complete.
Step 7 If Cisco Dock 7900 does not appear on the device list, press Rescan.
Step 8
From the device list, select Cisco Dock 7900 and press Pair.
Step 9 If prompted, enter 0000 for the passkey.
The pairing completes, the charger is listed in the Device List, and the charger is paired with the phone.
Step 10 Press the End button on the phone.
Dock Phone in Charger
When you undock the phone, Bluetooth disconnects and the phone uses the local speaker for audio.
Note If the Bluetooth disconnects when the phone is docked, undock and dock the phone again.
Before You Begin
The Cisco Unified Wireless IP Phone 7925G Desktop Charger must be connected to an electrical outlet or
have a charged, spare battery installed.
Procedure
Step 1 Place the phone into the charger, as shown in the following figure.
Cisco Unified Wireless IP Phone 7925G, 7925G-EX, and 7926G User Guide
6
Cisco Unified Wireless IP Phone 7925G Desktop Charger
> Phone Settings > Bluetooth.