To Protect The Non-Stick Finish - Panasonic SD-2501 Operating Instructions And Recipes

Care & Cleaning
Dispenser lid
Remove and wash with water.
 Raise the dispenser lid to an angle of approximately 75 degrees. Align the connections and pull
towards you to remove or push carefully back at the same angle to attach. (Wait until the machine has
cooled down first, because it will be very hot immediately after use)
 Take care not to damage or pull the seal. (Damage could lead to leakage of steam, condensation, or
deformation)
Seal

To protect the non-stick finish

Bread pan and kneading blade are coated with a non-stick finish to avoid stains and to make it easier to remove
bread.
To avoid damaging it, please follow the instructions below.
• Do not use hard utensils such as a knife or a fork when removing the bread from the bread pan.
When you have hard time taking out the bread from the bread pan, see P. 43.
• Ensure that the kneading blade is not embedded in the bread loaf before slicing it.
If it is embedded, wait for the loaf to cool and remove it. In removing the kneading blade,
press on the base of the loaf and manipulate the kneading blade gently to avoid damaging the loaf.
(Do not use hard or sharp utensils such as a knife or a fork.)
Be careful not to get burns as the kneading blade may still be hot.
• Use a soft sponge when cleaning the bread pan and the kneading blade.
Do not use anything abrasive such as cleansers or scouring pads.
 Hard, coarse or large ingredients such as flours with whole or ground grains, sugar, or the addition of nuts and seeds may damage
the non-stick finish of the bread pan. If using large chunk of ingredient, break into small pieces. Please make sure to follow the recipe
quantities stated.
42
Raisin nut dispenser
Remove and wash with water.
 Wash after each use to remove any residue.